kdFi V1.4 PNP BMW M50
Product information "kdFi V1.4 PNP BMW M50"
The kdFi V1.4 is installed in a Motronic compatible housing and loaded with an initial setup for M50 engines.
Also note our new and further developed product: UAB BMW M50
The control unit can be used on the M50B20 as well as on the M50B25 as a replacement for the following Bosch Motronics:
0 261 200 400
0 261 200 402
0 261 200 403
0 261 200 405
0 261 200 412
If your number is not listed, please contact us, using the contact form.
Customer to do:
- Change Engine Management
- START ENGINE !
- do your own setup
This product is only street legal with special permission in most countries. Please check local laws before using on official streets.
Automatic transmissions are currently not supported.
Features:
- Alpha-N based setup (can be changed to MAP sensor via software)
- also suitable for turbo and compressor conversions
- full compatible to MSextra Software
- build your own setup
- MS2 onboard / Firmware MS2extra
- Fuel Table 16x16
- Ignition Table 12x12
- USB Connector
- Widebandlambdacontroller (www.breitband-lambda.de)
- supports stock coils and injectors
- supports stock idle valves
- user programmable relay output
- electronical boost control
- supports CAN Bus
-compatible with the Lambda Sensor LSU 4.2
Scope of delivery:
- kdFi V1.4 Plug and Play ECU
- USB Cable
- kdFi Manual
- from 01.05.24 no CD included, download software CD under available downloads
Accessories
